G0 Z1.00 X20.0 Y20.# A newline separated list of X,Y points that should be probed # Use PRINT_END for the slicer ending script - please customise for your slicer of choice # Use PRINT_START for the slicer starting script - please customise for your slicer of choice SET_LED LED=btt_mini12864 RED=1 GREEN=0 BLUE=0 INDEX=3 SET_LED LED=btt_mini12864 RED=1 GREEN=0 BLUE=0 INDEX=2 TRANSMIT=0 SET_LED LED=btt_mini12864 RED=1 GREEN=1 BLUE=1 INDEX=1 TRANSMIT=0 # Index 1 = display, Index 2 and 3 = Knob # Set RGB values on boot up for each Neopixel. # To control Neopixel RGB in mini12864 display # See the sample-lcd.cfg file for definitions of common LCD displays. # If you are experiencing back flow, you can reduce fan_speedĮXP1_5=PE13, EXP1_6=PE14, # Slot in the socket on this sideĮXP2_5=PE7, EXP2_6=PB11, # Slot in the socket on this side # if your fan is not able to slow down effectively #ĝepending on your fan, you may need to increase this value Pin_up_touch_mode_reports_triggered: False #Ědjust Max Power so your heater doesn't warp your bed Sensor_type: ATC Semitec 104NT-4-R025H42G Max_z_velocity: 15 #Max 15 for 12V TMC Drivers, can increase for 24V #serial: /dev/serial/by-id/usb-Klipper_stm32g0b1xx_m8p-if00 ** PLEASE READ THROUGH AND USE AT YOUR OWN RISK ** TeachingTeach and Ellis3dp touch on the subject. Guide for tuning your esteps has been listed above. PID_CALIBRATE HEATER=heater_bed TARGET=60 To PID tune your heated bed in klipper use the following code pasted into your mainsail console. To PID tune your hotend in klipper use the following code pasted into your console via mainsail. This is the lines which are currently commented out with # Our config has a second mcu setup for input shaper. MCU serial can be found by following the directions found on the klipper docs. Though it could go faster, it shakes up the cabinet it is mounted in. Ive tuned this to a reasonably fast speed. You will still have to tune your esteps and PID tune your heated bed and hotend. Even with all the exact same parts you will have to pay attention to your end stop locations & the mcu serial. Using a different board will completely change everything. Please note, this klipper config is made to use with the parts we listed above.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |